用户登录
期刊信息
  • 主管单位:
  • 中国科学技术协会
  • 主办单位:
  • 中国仪器仪表学会、上海光学仪器研究所、中国光学学会工程光学专业委员会
  • 主  编:
  • 庄松林
  • 地  址:
  • 上海市军工路516号上海理工大学《光学仪器》编辑部
  • 邮政编码:
  • 200093
  • 联系电话:
  • 021-55270110
  • 电子邮件:
  • gxyq@usst.edu.cn
  • 国际标准刊号:
  • 1005-5630
  • 国内统一刊号:
  • 31-1504/TH
  • 邮发代号:
  • 单  价:
  • 15.00
  • 定  价:
  • 90.00
基于FPGA的面阵CCD驱动时序设计
The design of drive timing generation of array CCD based on FPGA
投稿时间:2013-11-20  
DOI:10.3969/j.issn.1005-5630.2014.01.014
中文关键词:  面阵CCD  行间转移  驱动时序  FPGA
英文关键词:area CCD  Interline transfer  driving timing sequence  FPGA
基金项目:
作者单位
韩军 西安工业大学 光电工程学院, 陕西 西安 710025 
杨少华 西安工业大学 光电工程学院, 陕西 西安 710025 
尚小燕 西安工业大学 光电工程学院, 陕西 西安 710025 
摘要点击次数: 3055
全文下载次数: 2770
中文摘要:
      针对柯达公司的前照明行间转移型面阵CCD KAI-0340,对它的驱动时序进行详细的分析,设计满足CCD工作脉冲的驱动时序。采用Altera公司的可编程逻辑器件(FPGA)作为核心控制器件,完成自顶而下的模块设计,实现了硬件电路设计的软件化,开发效率得到了提高,软件程序可重复编程和修改。实验的仿真结果表明,设计的驱动时序能够满足CCD KAI-0340的正常工作。
英文摘要:
      A detailed analysis was carried out of the requirements of the driving timing sequence of the progressive scan interline CCD KAI-0340 produced by Kodak Company. The programmable logic device(FPGA)of Altera Company was used for designing CCD driving timing sequence, which could enable the use of software in the designing of hardware circuit and improve development efficiency because the software was reprogrammable and modifiable. Results of experimental simulation showed that the designed sequence could meet the demand of the CCD KAI-0340.
HTML   查看全文  查看/发表评论  下载PDF阅读器
关闭